|
Kenwood TH- 25AT mods
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
TH25AT.7
If the
radio is positioned on its back, with the top folded over so that the
touch tone pad is also facing down, the test point you want (TP1) is on
the bottom half of the radio, near the center (left to right), and close
to the battery; the tuning pot you want (TC1) is on the bottom, and
closest to the PTT switch. Under no circumstances change the tuning of
TC51. This is used to calibrate the output of the radio with the
display the radio is giving; you don't want to mess with it. Once
again, the Service Manual makes it very clear where these points are, if
you are having trouble with my descriptions. On with retuning the PLL.
With the radio on, and receiving, monitor the voltage and the waveform
on test point TC1. Tune the radio DOWNWARDS in frequency until the PLL
unlocks. Note that the radio will beep when this happens, and the
waveform on TP1 will change.
CONTINUED IN FILE TH25AT.12
|
|