|
Modification for Icom 32at
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
IC32AT.3
Hello everybody, new radios are getting more and more complicated, don't you
agree?
Here is a modification for the new Handheld Icom IC-32 which will make it act
as a cross band repeater!
1. First take off the battery pack.
2. Remove the 4 screws from radio's back.
3. Remove two screws above and below the PTT and take the whole thing off
so the four microswitches are revealed.
4. Take carefully the radio apart by slightly pushing away the front cover.
5. Put the two pieces in front of you with the front part at your left and
the back at your right. Be carefull with the ribbon joining the two
pieces!!! Orientation is as usual with the place that the battery plugs
down and the top of radio (i.e. where the antenna goes) up.
6. Find some pads with diodes in the lower right of the left part (front) of
the radio below to the speaker.Take a look in the drawing below:
CONTINUED IN FILE IC32AT.10
|
|