|
Modification for Icom 32at
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
ic32at.15
9. But, the further you get from the ham band, the more unstable the rig is.
If there's a U where the memory channel should be, you've lost phase lock.
10. Install a diode at 5 if you want to make your rig a crossband repeater.
11. Do a CPU reset by holding both FUNCTION and [A] then turning on power.
12. For crossband repeater operation, enter a simplex frequency in the VHF
VFO and then enter a simplex frequency in the UHF VFO. Hold FUNCTION and
consecutively press [C] [6] [D].
13. To stop crossband repeater operation, you must be in receive mode (i.e.,
nobody transmitting). Hold FUNCTION and consecutively press [D] [C].
DIODE LOCATIONS & FUNCTIONS:
(At the LEFT of the back of the speaker, counting from top down)
(Original diode locations marked with *)
1. Install for 10 MHZ digit keypad entry
* 2. Leave in place for expanded VHF receive
3. ?
* 4. Remove for expanded UHF receive
5. Install for crossband repeater operation
Downloaded From P-80 International Information Systems 304-744-2253
|
|