|
Icom IC3220A/H band expansion, mini- repeater
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
IC3220A
ICOM IC-3220A/H
Frequency expansion/Mini repeater
Frequency expansion:
To extend the receiver range on VHF:
118.000mhz (AM) to 174.000mhz (FM)
Cut D6 on the LOGIC board (located on the front of the radio)
To extend the receiver range on UHF:
400.000mhz to 479.000mhz
Cut D4 on the LOGIC board.
To extend transmitter range on VHF:
136.000mhz to 174.000
Solder a bridge between the solder pads next to D9
To extend transmitter range on UHF:
400.000mhz to 479.000mhz
Install 1SS190 (diode) at D9 position on the LOGIC board.
MINI REPEATER FUNCTION
1. Set rig to "DUAL" by using the BAND switch.
2. Set frequencies in VHF and UHF. You may set in offset on
either band. You may also set it up in VFO or MEMORY.
3. Simultaneously hold BAND and SET key. The memory number
will display a flashing "L". It will be in repeater mode
To disable repeater mode, depress and hold "SET" key until
the flashing "L" goes to a memory number or VFO mode.
The repeater mode will not be disabled by turning the rig off
and on.
|
|
