|
Icom 2A/3A/O2AT mods
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
IC2AT.2
5. solder a store bought 1n914 or 1n4148 diode from the top
pad to the bottom left pad of d4. you will need to bend
and cut the leads of the diode and pre-tin with solder.
bend the leads of the diode so that the body of the
diode lays across the bottom right pad covering it up.
the banded end of the the diode should be facing down
towards mhe bottom right pad.
now you are ready to follow steps 7 to 13 and the rest of the
instructions in the article. the only difference you will find
is that a letter "u" will flash to indicate unlocked instead
of the entire display flashing. gud luck and enjoy the fruits
of you labor. if you are unable to locate the article pls
send sase to: ka1ghf
po box 1397
leominster, mass 01453
73's de ka1ghf "peter" RELAYED BY...N0KGX...GENE
Downloaded From P-80 International Information Systems 304-744-2253
|
|