|
Icom 2A/3A/O2AT mods
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
IC2AT.1
icom 02at mod 140-163 mhz
a. locate a copy of the june 1986 issue of 73 mag.
a. locate a copy of the june 1986 issue of 73 mag.
b. the article on pg. 60 is for models with id numbers
lower than 35,000. if yours is one of the newer
models like mine..... then follow these changes:
1. read the entire article b-4 doing anything!!!
2. follow steps 1 to 3 on pg. 61 "modify ur 02at"
then s t o p ! refer to fig.2 on pg. 60 and remember
the diodes on urs are in different locations than in
the pix.
3. using a very small flat blade iron and some solder wick
remove the the three leg diode d2 notice that the
numbering for d1,d2,d3,d4 are off to the left of the
actual location of the diodes on the board.
4. resolder d2 down in position d5 try to use the solder
on the pads.. only add solder to the pads if absolutely
necessary, b-4 you put the diode in place to avoid
bridging.
CONTINUED IN FILE IC2AT.2
|
|
