|
Mod for Icom 24at
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
IC24AT.5
FUNC + 7 = Priority mode on/off (operation dependent on current mode)
FUNC + 8 = Set mode (several different functions, press A to exit)
FUNC + 9 = Real time clock and timer functions (press PTT to exit)
FUNC + A = Memory to VFO transfer
FUNC + B = Memory Write
FUNC + C = Split operation (cross band full duplex)
FUNC + D = Lock mode / Cross Band Repeat disable
FUNC + * = Scan programmed limits (down)
FUNC + # = Scan programmed limits (up)
FUNC + 5 + D = Cross Band Repeat enable (split mode must be on!)
Diode D14 (right diode on CPU board) must be removed to
enable the use of this function)
FUNC + MONI = RX/TX light enable / disable
FUNC + H/L/DTMF = Select DTMF Autodialer memory
Func + VFO knob = Change frequency/memory channel
(according to dial set, see FUNC+0)
Func + LIGHT = Lock light on (don't time out)
H/L/DTMF + VFO knob = Change output power (4 power levels when using 13.8 vdc)
The following key combinations selects "power on modes". Start with the radio
OFF, then hold down the indicated keys, and continue to hold them while turning
the power ON. Some 'modes' override others.
LIGHT + * = PTT enable
LIGHT + 0 = PTT Disabled (inhibits the transmitter, good security method)
LIGHT + 1 = 1 MHz digit set (4 digit frequency entry)
LIGHT + 2 = 10 MHz digit set (5 digit frequency entry)
LIGHT + 3 = 100 MHz digit set (6 digit frequency entry)
LIGHT + 4 = Scan pause until signal disappears
LIGHT + 5 = Scan pause for 10 seconds
LIGHT + 6 = ???? Unknown action
CONTINUED IN IC24AT.6
Downloaded From P-80 International Information Systems 304-744-2253
|
|