|
Mod for Icom 24at
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
IC24AT.4
Subject: ICOM IC24AT keyboard command summary
This is an attempt to document all of the known key sequences for the ICO
IC24AT (144/440MHz dual band hand held). Some key sequences may be common
with the IC[2,3,4]SAT, therefore a fewkey seqences fr thoseradios re also
on this list. Some ke sequenes requre optins (such as the PL encode/decode
board).
This is not designed to replace the owners manual, but to summarize the
information in one place.
Note: Many controls vary depending on the current mode, i.e.: Scan up/down
will search frequencies when in VFO mode, and will scan meory channels when
in Memory mode. Consult the owners guide for complete iformation.
KEY/COMBINATION = Result, action
---------------- -------------------------------------------------------------
0-9,A,B,C,D,#,* = note: when transmitting these will generate DTMF tones
0-9 = Enter frequency (can also use the VFO knob)
A = VFO mode / clear incomplete entry
B = Memory mode
C = VHF / UHF change
D = Call channel
* = Step frequency down/scan down
# = Step frequency up/scan up
MONI = Open squelch and change to input frequency (if not simplex)
while button is depressed
H/L/DTMF = Select High/Low power, or (while transmitting) send
preprogrammed DTMF codes
FUNC + 0 = Dial set
FUNC + 1 = PL enable (when option is installed)
FUNC + 2 = Code squelch [NOT for the IC24AT, IC[2,3,4]SAT option only]
FUNC + 3 = Skip memory
FUNC + 4 = Duplexoperatin
FUNC + 5 = Code [NOT for the IC24AT, IC[2,3,4]SAT option only]
FUNC + 6 = Mask freuency
CONTINUED IN IC24AT.5
Downloaded From P-80 International Information Systems 304-744-2253
|
|
