|
Mod for Icom 24at
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
IC24AT.3
AM AIRCRAFT RECEIVE PLUS 740 to 960 MHz RECEIVE
Remove D13 from the main logic board (this diode may already be
removed by ICOM in some units). This diode may already be
removed in some radios. D13 is on the main logic board and is a
discreet diode (one of the two in the radio) near the center of
the board. It is the left discreet diode of the two on the board
when the radio is open and held with the controls away from you.
Simultaneously hold "Light", "B", and "#" keys depressed and turn
power on.
It is important to note that the radio will not meet specifica-
tion on the out of band receive frequencies that are enabled with
this modification.
DIRECT KEYBOARD ENTRY of 100 MHz FREQUENCY
Simultaneously hold "Light" and "3" keys depressed and turn power
on.
CROSS BAND REPEAT (simplex)
Remove D14 from the main logic board (tiis diode may already be
removed by ICOM in some units). The diode is a discreet diode to
the right of D13 (from above) and directly beside it.
Simultaneously hold "Funct" depressed and push "C".
To turn on cross band repeat:
Hold "Funct" depressed then push "5" and then push "D".
To turn off cross band repeat simultaneously hold "Funct" and "D"
depressed.
%***********************
NOTE: I haven't tested these, proceed at your own risk! WA2ISE
------------------------
A notice found on a piece of test equipment made in Japan:
"IT PUT ON THE VINYL SHEET ON THE SURFACE OF UPPER & LOWER PANEL FOR THE
PROTECTION PLEASE USE AFTER TEAR OFF VINYL SHEET WHEN USING.
Downloaded From P-80 International Information Systems 304-744-2253
|
|