|
More HR- 2510 mods
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
PS: I'm searching for HR-2600 Frequency Modification. Daniel VE2BAP '
VE2CSC.PQ.CAN.NA
FREQUENCY MODIFICATION: PRESIDENT/UNIDEN HR-2510:
The 10-meter mobile amateur transceiver will transmit and receive from 26.000
MHz to 29.9999 MHz when the following modifications are performed:
1) Locate the CPU: IC 315 (UC-1201).
2) Pin 34 and 35 are together grounded (see the bottom - solder side). Cut the
PCB Pattern to disconnect the pins 34 and 35 from ground. Now, both pins are
free from ground and floating.
3) To activate 26.000 to 27.999 MHz (pin 35) and 29.7 to 29.999 MHz (pin 34),
just add 10 K ohms, 1/4W resistor between the pattern of pin 34 and 35 to the
pattern of DC+5V line.
NOTE: The display will indicate the EXACT 40 CB CHANNELS (Yes sir!) when "G"
band is selected.
---------------------------------------
POWER OUTPUT MODIFICATION: HR-2510 and Realistic HTX-100.
Transmitter power output of these rigs can be increased up to 100 Watt (SSB),
when an easy modification/tune up is done. Complete details can be found in
73 AMATEUR RADIO, september 1989, p. 48
Daniel VE2BAP @ VE2CSC.PQ.CAN.NA
*******************************************************************************
|
|
