About
Community
Bad Ideas
Drugs
Booze - The Legal Drug
Legal Issues of Drug Use
Marijuana
Miscellaneous Drug Information
Nitrous
OTC Drugs and Household Items
Psychedelics
Rare and Exotic Drugs
Speedy Drugs
Ego
Erotica
Fringe
Society
Technology
register | bbs | search | rss | faq | about
meet up | add to del.icio.us | digg it

Heroin Methodology


NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.

This information is only for people who are mature enough to respect the dangers involved with injecting heroin. These dangers include physical and mental addiction and the possibility of contracting a terrible disease like AIDS or hepatitis if the user doesn't take the time to be as sanitary as possible and NOT SHARE NEEDLES.

-Alcohol swabs are available in a box of about 100 for $2 at Safeway.

-A commonly used syringe is the U-100. It is 1CC which is divided into 100 "units".

-The bottom of a soda pop can is commonly used as a "spoon" to dissolve the heroin in because it is curved inward like a spoon. The bottom is torn off of a can as close to the bottom as possible.

Procedure:

The "spoon" is thoroughly cleaned with an alcohol swab. In this example black tar heroin is used. In my area a $15 chunk is about the size of 2 tic-tac candies side-by-side and works just fine. It has no smell exept for a faint smell of vinegar. It comes wrapped in plastic inside a tiny balloon. A chunk is placed in the spoon. The syringe is used to suck up about 50-75 units of water and squirt it into the spoon. The spoon is then heated from the bottom with a lighter to make it dissolve better. The plunger can be pulled out of the syringe and used to stir the heroin solution. The end of the plunger should be clean before putting it back in the syringe. A piece of cotton is rolled into a ball a little bigger than a tic-tac. It is a good idea to clean one's fingers with an alcohol swab before rolling the cotton. The cotton is dropped into the heroin and it puffs up like a sponge. The tip of the syringe is pushed into the center of the cotton and the plunger is slowly pulled back until all of the heroin is sucked in. This cotton is necessary to filter out any particles and such in the heroin solution. The area on the body chosen for injection is thoroughly cleaned with an alcohol swab. I think the spot on the bend of the arm is so commonly used because it's so darned easy to get the needle into the vein properly. The needle is placed almost flat on the skin so it doesn't get wiggled around too much. The needle is inserted so it goes down the length of the vein and not across it. Going across it just makes it way too easy to accidentally poke through the other side or pull out. Holding the syringe almost flat against the skin after the user feels the needle is deep enough in keeps the syringe from accidentally being jostled around and the needle being pulled out or pushed through the side of the vein.

Now for the tricky part. The user has to make sure that the needle is in the vein before injecting. If the heroin is injected when the needle isn't in the vein the heroin will just form a big heroin blister which takes hours and hours to get absorbed by the body. Usually it will burn while it's being injected if it's not going in the vein. This is one way to tell if it's not going in the vein. The user should also keep a close eye to see if a blister is forming. When the needle is inserted the plunger is pulled slowly a tiny bit to see if blood comes in. This shows that it's in the vein. Sometimes when the plunger is pulled, only a slow trickle of blood comes in and the rest is air. With practice it's easier to tell if this trickle indicates a good enough insertion into the vein. Injecting a tiny bit of air ( about an eighth-inch ) with the heroin is harmless but if the user is nervous about this the syringe could be tilted so the air floats to the other end. From personal experience a quarter- inch (about 10 units) of air being injected with heroin is harmless but there's no need to make a habit of injecting air. With a little practice the user can be pretty sure the heroin is going in the vein without first checking for blood but still checking for a burning feeling where it's being injected or a blister forming.

When trying heroin for the first time the user, of course, starts out with a tiny bit to see how his or her body reacts to it. As with pain pills sometimes the stomach gets queasy when the body isn't used to it. In the case of an overdose the only thing I know to do is to keep the person up and walking around to keep the heart going. If medical attention is needed I'm pretty sure the paramedics use a drug called "narcan" which blocks the effects of opiate narcotics like heroin.

 
To the best of our knowledge, the text on this page may be freely reproduced and distributed.
If you have any questions about this, please check out our Copyright Policy.

 

totse.com certificate signatures
 
 
About | Advertise | Bad Ideas | Community | Contact Us | Copyright Policy | Drugs | Ego | Erotica
FAQ | Fringe | Link to totse.com | Search | Society | Submissions | Technology
Hot Topics
hot naptha bath
Oxycodone from Codeine
yes another nano thread...
hughjorgen + annie
Extraction of menthol from petroleum jelly
epinephrine inhaler?
Pesticide synth
the raid thread
 
Sponsored Links
 
Ads presented by the
AdBrite Ad Network

 

TSHIRT HELL T-SHIRTS