An English Bong - Shottie Bottle
by The Kat
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
Apparently this is the way to make a type of bong which is commonly known as a Shottie in the UK.
Step 1 - get a bottle the best apaprently are the Pepsi bottle.. just the little ones with the wide neck. Take off cap and discard.
Step 2 - find a tube.. metal, about 1cm across. Things like parts of cars, or anything works well. Apparently.
Step 3 - Make a hole in the bottle. This is best done or so i'm told by warming the end of the metal tube and pushing it through the plasic. Alternatively hack the bastard up with scissors. MAKE SURE THE HOLE IS NO BIGGER THAN THE TUBE.
Step 4 - Insert tube and fill the bottle with water.. just below where the hole is. The Tube should be able to comfortable hang downwards slightly into the bottle without touching the sides or back of the bottle.
Step 5 - Take a tiny bit of tabbacoo roll between finger and place at end of tube (can be removed for packing) dab the end into grated resin. The harshness of the shottie depends on the amount of baccy. More baccy the more harsh it is.
Step 6 -HOW TO RIP A SHOTTIE using a lighter over the end of the tube cream the shottie up by sucking gently, DO NOT INHALE YET. Wait until white ash forms on the end of the tube (well inside) then RIP IT BACK. The tabbaco will drop into the water allowing the shottie to be ripped back.
HELPFUL HINTS.
Thinner tubes make it more difficult to rip the shottie.. 1 cm in diameter seems to work the best. Or so i'm told.
The baccy in the tube is NOT meant to be burnt but to support to grated resin.
If you feel the need to cough, supress it otherwise you'll be coughing for hours.
Enjoy!
|