About
Community
Bad Ideas
Guns & Weapons
Irresponsible Activities
KA-FUCKING-BOOM!
Locks and Security
Scams and Rip-offs
Drugs
Ego
Erotica
Fringe
Society
Technology
register | bbs | search | rss | faq | about
meet up | add to del.icio.us | digg it

Breaking into phone coin boxes


NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.


To all people who don't believe in giving
the phone company 25 cents for
a call, or even a dime, this is for you

I don't know about the rest of the
country but here in N.Y.C. they have
armored the pay-phones with steel
plates surrounding the bottom half of
the phone. This shield will withstand
any attack by M-80's, block-busters,
super-blockbusters, ash-cans,
pineapples, etc...... (Except Dynamite)
to destroy this plating and most of the
bottom half of the phone, use the
following device.

First you must blow out the hinge on the
coin return slot. This can be done with
most conventional weapons such as a
block-buster.
Then, take a 6 inch section of the same
type of bendable metal tubing that
surrounds the wire to the receiver,
but it must be at least 1 inch in dia-
meter.

Then, solder a piece of sheet metal on
to one side of the tube to seal that
side. Then fill the tube with the same
flash-powder used in block-busters and
fill that end with strong epoxy to seal
it.

One thing I forgot to mention, before
soldering the round piece of sheet
metal to the tube, drill a small hole
in it just big enough to fit a piece of
demolition fuse through. Then put the
piece through before filling it.Seal
the edges of the fuse with the same
epoxy used to seal the opposite end of
the tube.

Then, when complete, shove the thing
up into the coin slot with the epoxy
end going in first.

Next thing you know you've got dimes,
nickels, and quarters falling all around
you.


***Downloaded From The TerrorDome BBS***


 
To the best of our knowledge, the text on this page may be freely reproduced and distributed.
If you have any questions about this, please check out our Copyright Policy.

 

totse.com certificate signatures
 
 
About | Advertise | Bad Ideas | Community | Contact Us | Copyright Policy | Drugs | Ego | Erotica
FAQ | Fringe | Link to totse.com | Search | Society | Submissions | Technology
Hot Topics
Free Logitech Products Wihtout Owning
Urban Exploration
graffiti on google earth.
joining the military.
Cutting the gas line
How do I get rid of my roommate?
The Xbox 360 switch
How to Really Succeed at Bad Ideas
 
Sponsored Links
 
Ads presented by the
AdBrite Ad Network

 
www.pigdog.org
 

TSHIRT HELL T-SHIRTS