RDX or Cyclotrimethylenetrinitramine
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
R.D.X., also called cyclonite, or composition C-1 (when mixed with
plasticisers) is one of the most valuable of all military explosives. This is
because it has more than 150% of the power of T.N.T., and is much easier to
detonate. It should not be used alone, since it can be set off by a not-too
severe shock. It is less sensitive than mercury fulminate, or nitroglycerine,
but it is still too sensitive to be used alone. R.D.X. can be made by the
surprisingly simple method outlined hereafter. It is much easier to make in the
home than all other high explosives, with the possible exception of ammonium
nitrate.
Also referred to as hexogen, RDX is a white crystalline solid usually used in mixtures with other explosives, oils, or waxes; it is rarely used alone. It has a high degree of stability in storage and is considered the most powerful and brisant of the military high explosives.
RDX compositions are mixtures of RDX, other explosive ingredients, and desensitizers or plasticizers. Incorporated with other explosives or inert material at the manufacturing plants, RDX forms the base for the following common military explosives: Composition A, composition B, composition C, HBX, H-6 and Cyclotol.
Hexahydro-1,3,5-trinitro-1,3,5-triazine, commonly known as RDX (Royal Demolition eXplosive), is a hexacyclic ring containing six nitrogen atoms. RDX is a synthetic product that does not occur naturally in the environment. RDX is also known as cyclonite and hexagen. RDX is widely used by the military. In 1972, 102,000,000 pounds of RDX was produced in the United States.
RDX can enter the environment through the manufacturing process or improper handling and disposal methods. It has been estimated that up to 12 mg/liter of RDX may be discharged into the environment through process wastewater used in RDX manufacturing. Alternatively, RDX can contaminate water and soil from spills orleaks at hazardous waste disposal sites. Airborne contamination of RDX occurs when it is disposed of by burning.
Cyclic nitramine explosive compounds have been proven to be toxic. Acute health effects of inhaling or eating RDX are seizures. Chronic health effect from long-term exposure to low levels of RDX have not been determined in humans. However, RDX has been shown to decrease body weight and damage the liver and kidneys of rats and mice. The effects of RDX on reproduction are not known yet.
It has a cyclic structure with a six-membered ring of alternating CH2 groups and nitrogen atoms, with each nitrogen being attached to a NO2 group. It is made by nitrating hexamine, C6H12N4, which is obtained from ammonia and methanal.
MATERIALS
hexamine or methenamine fuel tablets (50 g)
concentrated nitric acid (550 ml)
distilled water
table salt
ice
ammonium nitrate
EQUIPMENT
500 ml beaker
glass stirring rod
funnel and filter paper
ice bath container(plastic bucket)
centigrade thermometer
blue litmus paper
1) Place the beaker in the ice bath, (see section 3.13, steps 3-4) and carefully
pour 550 ml of concentrated nitric acid into the beaker.
2) When the acid has cooled to below 20 degrees centigrade, add small amounts of
the crushed fuel tablets to the beaker. The temperature will rise, and it
must be kept below 30 degrees centigrade, or dire consequences could result.
Stir the mixture.
3) Drop the temperature below zero degrees centigrade, either by adding more ice
and salt to the old ice bath, or by creating a new ice bath. Or, ammonium
nitrate could be added to the old ice bath, since it becomes cold when it is
put in water. Continue stirring the mixture, keeping the temperature below
zero degrees centigrade for at least twenty minutes
4) Pour the mixture into a litre of crushed ice. Shake and stir the mixture,
and allow it to melt. Once it has melted, filter out the crystals, and
dispose of the corrosive liquid.
5) Place the crystals into one half a litre of boiling distilled water. Filter
the crystals, and test them with the blue litmus paper. Repeat steps 4 and 5
until the litmus paper remains blue. This will make the crystals more stable
and safe.
6) Store the crystals wet until ready for use. Allow them to dry completely
using them. R.D.X. is not stable enough to use alone as an explosive.
7) Composition C-1 can be made by mixing 88.3% R.D.X. (by weight) with 11.1%
mineral oil, and 0.6% lecithin. Kneed these material together in a plastic
bag. This is a good way to desensitize the explosive.
8) H.M.X. is a mixture of T.N.T. and R.D.X.; the ratio is 50/50, by weight.
it is not as sensitive, and is almost as powerful as straight R.D.X.
9) By adding ammonium nitrate to the crystals of R.D.X. after step 5, it should
be possible to desensitize the R.D.X. and increase its power, since ammonium
nitrate is very insensitive and powerful. Soduim or potassium nitrate could
also be added; a small quantity is sufficient to stabilize the R.D.X.
10) R.D.X. detonates at a rate of 8550 meters/second when it is compressed to a
density of 1.55 g/cubic cm.
Another procedure:
1. Mix 250 grams powdered hexamine with 50 grams powdered ammonium nitrate.
2. Very slowly add this to 500ml beaker (in ice bath) containing 200ml industrial strength nitric acid.
3. Once all the hexamine/NH4NO3 has dissolved, gently elevate the temperature to 70 degrees celcius, and let it sit until crystals percipitate. Once that happens, lower the temperate to 50 degrees.
4. Decant crystals and wash them with ethyl alcohol. If high acidity, add baking soda until neutral.
|