Anarchist's Corner - CO2 Bombs
by piro
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
Hello and welcome to the first edition of the anarchist's corner...
My name is piro and I will be your host for this section.
In this edition we will discuss how to make and use a simple, tiny, and
powerful bomb that I like to call the co2 bomb. it is widely used by many
anarchists and pyrotechics around the country for taking out mailboxes,
toilets, and blowing out locks. It can also be used in conjunction with other
items such as rockets or nut busters (shown in a later article) or as a
blasting cap for larger bombs (propane or other natural gases). It can also be
used for crowd control or killing if shrapnel is added.
What you need:
An empty co2 canister - used cartredges from air guns - any size or carbonating machines (12g.) or lifevests on airoplanes (16g. usually)
gunpowder or something - a gun store for reloading (making) similar.
a hole puncher - hardware store for punching holes in leather
fuse - (preferably cannon - cannon is the fuse of choice because it burns at a steady rate and is water proof) it can be bought either at a well stocked gun
store or a well stocked fireworks distributor.
a thick pice of paper or a tiny funnel - hardware store, kitchenware section of department store or your own kitchen. the paper on the other hand can be notebook paper as long it's not too thin.
shrapnel (optional) - tiny bb's or buckshot or tiny slivers of metal.
procedure:
1. Use hole puncher to widen the already pierced hole at the neck of the cartridge. Widen it as muchcan (usually about 3mm. wide)
1.5 You have the choice of putting a tiny bit of shrapnel in. Not too much,
just about 1/8 full should do it.
2. Either fold the paper in half and direct the powder down slowly into
the neck of the cartridge by the crease or use the funnel. the idea is to fill
the cartridge with the powder.
3. Insert the fuse, preferably 6 inches because you really want to be no
where near this when it goes off.
4. Presto! you now have a ready to light co2 bomb that can be lit and
thrown!!!
For timed fuses for anything with cannon fuse (if you or a friend smokes).
light the cigarette and break off the filter. Then place the unlit side into
the cannon fuse until it is weged on but still an inch or two away from the lit
part. Then place it somewhere (a trash can in a public place) and wait between
5 and 10 minutes.
This bomb is not impact explosive (in the case of gunpowder) if your incindeary
is not inpact explosive so it is relitively safe as long as bombs are
concerned. Shrapnel is very dangerous because it will go everywhare and it is
molten metal ripping and tearing the skin. So please take extreme care. If
placed on the ground it will travel in the air for several feet. Also can send out bits of it's own shell even if you don't add shrapnel. All in all
dangerous to explode near civilians and will easily blow the top out of any
U.S. approved mailbox across the street.
It is also, by the way, my favorite bomb.
piro
|