|
Steel Casings
by Gray Chance
NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.
STEEL CASINGS
BY: GRAY CHANCE
OK, THIS IS BY FAR THE MOST DEADLY OF THE PIPE BOMBS. TAKE A STEEL ROD OF ANY
THICKNESS (PROBABLY AT LEAST 1/2") AND BORE OUT THE CENTER BY DRILLING IN FROM
ONE END. DONT DRILL ALL THE WAY THROUGH THOUGH. THEN DRILL A HOLE IN THE SIDE
FOR THE FUSE. FOLLOW THE SAME METHOD FOR CAPPING THE OPEN END AS IS DONE WITH
REGULAR PIPE BOMBS. THE NICE THING ABOUT STEEL IS ITS STRENGTH. THE THICKER YOU
MAKE THE WALLS OF THE BOMB, THE BIGGER THE BANG. SIZE HELPS ALSO. THERES ONLY
ONE PROBLEM WITH IT THOUGH- THE CAP AT ONE END TENDS TO BLOW OFF IF ITS TOO
POWERFUL, OR IF THE CAP HOLDS, THEN ALL THE FUEL SHOOTS OUT THROUGH THE FUSE
HOLE. THERE IS A SOLUTION FOR EACH. TO KEEP THE CAP ON, MAKE A CLAMP OUT OF
STEEL THAT WRAPS AROUND THE BOMB FROM END TO END. THIS SHOULD HOLD IT IN PLACE.
FOR THE FUSE HOLE: DRILL A VERY TINY HOLE. THEN USE AN IGNITOR (PREFERABLY HOME
MADE) WITH INSULATED WIRES. THEN TAKE ANOTHER THIN STEEL CASING AND FIT THE
BOMB INSIDE IT ONLY THIS STEEL CASING DOESN'T HAVE A FUSE HOLE JUST RUN THE
LEADS OUT ONE END. USE YOUR STANDARD IGNITION SWITCH FOR ANY IGNITOR AND SET IT
OFF. IT WOULD PROBABLY BE SAFER TO USE A TIMER.
|
|