About
Community
Bad Ideas
Guns & Weapons
Irresponsible Activities
KA-FUCKING-BOOM!
Locks and Security
Scams and Rip-offs
Drugs
Ego
Erotica
Fringe
Society
Technology
register | bbs | search | rss | faq | about
meet up | add to del.icio.us | digg it

Makarov Silencer

by Prof. James Toadstool


NOTICE: TO ALL CONCERNED Certain text files and messages contained on this site deal with activities and devices which would be in violation of various Federal, State, and local laws if actually carried out or constructed. The webmasters of this site do not advocate the breaking of any law. Our text files and message bases are for informational purposes only. We recommend that you contact your local law enforcement officials before undertaking any project based upon any information obtained from this or any other web site. We do not guarantee that any of the information contained on this system is correct, workable, or factual. We are not responsible for, nor do we assume any liability for, damages resulting from the use of any information on this site.

Disclaimer: Niether the totse.com staff or the author of this file will be held responsible for the actions of those who maight attempt to use or misuse this information; which is strictly for educational purposes only.

For those of you who own a Makarov (9x18) pistol and want to silence it but lack the metal working equipment needed to manufacture most silencerzs then this file is foryou.

The following is from: More Workbench Silencers by George M. Hollenback

Materials needed:

+ 12 x 1 3/8 inch brass plumbing tube

+ 3/4 x 1/2 inch CPVC bushing

+ 1 x 3/4 PVC bushing (threaded)

+ 1 x 1/2 inch pvc bushing

+ barrel press and pin punch for the makarov pistol

+ threaded barrel thread protector for the pistol

+ cardboard, pencil, ruler, X-acto knife, epoxy

First remove the "fixed barrel" so that the extended threaded barrel may be attached.

Next Epoxy the thead protector into the 3/4 x 1/2 inch bushing.

Now Epoxy the 3/4 x 1/2 bushing into the 1 x 3/4 bushing.

The 1 x 3/4 bushing is then glued to the tube; cardboard washers are adeed and the 1 x 1/2 bushing is glued to the opposite end.

The silencer can now be installed on the firearm.

Here is how to construct cardboad washers:

Create a grid of squares on the cardboard that will of appropiate size for your suppresor. Cris-cross the squares to find the center the draw a circles for the washer and the bullet diameter in the center. Cut out the square and cut until the washer is roughly circular. The washers metioned here allow for a better over all fit than strait circles.

 
To the best of our knowledge, the text on this page may be freely reproduced and distributed.
If you have any questions about this, please check out our Copyright Policy.

 

totse.com certificate signatures
 
 
About | Advertise | Bad Ideas | Community | Contact Us | Copyright Policy | Drugs | Ego | Erotica
FAQ | Fringe | Link to totse.com | Search | Society | Submissions | Technology
Hot Topics
Plausible mixture, need expertise
i wanna make a bottle rocket
PVC end cap failiure.
Detonation by fire?
would this work???
so I've been googling around but:
Books
SHOOTER MOVIE ((Hollywood vs. Reality))
 
Sponsored Links
 
Ads presented by the
AdBrite Ad Network

 

TSHIRT HELL T-SHIRTS